Ultra Optics MR3 Standard Operating Procedure page 23

Flushing Coating System
Continued
Unscrew the elbow from the coating filter,
clean and set aside, this will be reused.
Follow the longer black tubing from the
coating pump up to the coating reservoir
and disconnect the nut from the straight
fitting on the bottom of reservoir.
Both coating tubes should now be free.
Disconnect the coating sensor at the 3 pin
harness on the left of the reservoir.
The coating reservoir can now be
unscrewed from the bowl by twisting it to the
left, allowing for easy cleaning.
Once the reservoir is removed, flush it out
using Acetone and allow to dry.
Make sure any debris in the reservoir has
been removed. Flush again if needed.
Unscrew the filter from the reducing coupler
and throw away.
Wipe out the coating bowl using a lint free
Alpha type cloth dampened with Acetone
and allow to dry.
21