Pre-Coating Lens Prep - Ultra Optics MR3 Standard Operating Procedure

Pre-Coating Lens Prep

Put on a clean pair of approved Nitrile
gloves.
Hold the lens backside up.
Keep fingers only on the edges of the
lens.
Squirt a quarter size amount of 90% IPA
or UOC Lens Cleaner on the backside of
the lens.
Using a finger with light pressure, clean
lens using a circular motion starting from
the center and moving towards the
outside edge.
Hold the lens in a vertical position.
Rinse the lens off into a waste container.
This will ensure the lens is as clean as
possible.
10