Table of Contents
Advertisement
Remove previously used material:
If material is currently loaded, remove it, making sure first to release the label roll.
•
Open the take-up spool lock lever.
•
Open the nip rollers.
•
Use a scissors to cut the label supply by the take-up spool so that you have enough leader material
(about 8 inches) to load the roll later without wasting labels.
•
Remove the used liner from unit and discard.
•
Remove the remaining label roll from the printer, making sure first to release the label roll.
•
Use tape to secure the end of the label roll. Be careful not to let the material spool unwind from the
core.
8. Place the new label supply roll on the spool.
9. Turn flange (A) counter-clockwise to rotate the label roll so the touch memory cell is securely
positioned in the reader clip (B).
BradyPrinter A5500 User Manual
CAUTION! Failure to release the label roll can damage the smart cell. Rotate
the flange behind the label roll clockwise so that the smart cell is
clear of the reader clip. Then pull forward to remove the label roll.
See Figure 4-2 for the location of the flange and the reader clip.
A
Figure 4-2. Flange and Reader Clip
Installation and Preparation
Load Label Supply
B
19
Advertisement
Table of Contents
