Table of Contents
Advertisement
4. Orient the flat spot in the ribbon roll to align with the feed spool and slide it on the spool until it
contacts the back wall.
5. Thread the ribbon under the guide roller and over the guide bar and printhead. See
on page
6. Feed ribbon under the clip (A) as shown until approximately 1 inch (25.4 mm) of ribbon is past
the clip.
7. Turn the take-up spool knob (B) counter-clockwise until the ribbon is fed around the take-up
spool several times to ensure that it won't unravel.
Note: Make sure that the ribbon roll is installed flush to the back flange and routed.
8. Close the side door of the printer.
9. On the touch screen, tap Done.
This moves the print assembly forward into the home position.
10. Return to the home screen.
BradyPrinter A5500 User Manual
23.
A
Installation and Preparation
Load the Printer Ribbon
Figure 4-4
B
25
Advertisement
Table of Contents
