Table of Contents
Advertisement
1. On the BradyPrinter A5500 home screen, tap Load Supplies.
2. Tap Load Ribbon.
3. Lift the side door of the printer.
Note: Ribbon threading instructions are also located on the inside of the side door.
Remove the old ribbon
If ribbon is currently loaded, remove it:
•
Cut the ribbon between the guide bar and take-up spool.
•
Hold the edge of the take-up spool while turning the knob clockwise until it stops.
•
Pull the take-up spool knob to remove the used ribbon from the take-up spool and discard.
•
Re-engage the take-up spool by pushing it in all the way until the knob auto-rotates back to its
original position. Failure to re-engage the take-up spool will make it difficult to remove the
old ribbon next time!
•
Remove remaining ribbon, if any, from the feed spool.
•
Use tape to secure the end of the ribbon roll.
BradyPrinter A5500 User Manual
Installation and Preparation
Load the Printer Ribbon
24
Advertisement
Table of Contents
