Loading The Material - Brady IP Quick Start Manual

NOTE: To remove ribbon from the ribbon take-up spindle, press and hold
the thumb lever (Figure 14, 4) to compress the spindle and slide
the spent ribbon off the spindle.

Loading the Material

1. Green tab
2. End piece
1. Remove the material supply holder (Figure 15) from the printer by lifting it
up and out of the frame.
There are electrical contacts located under the
side tabs (Figure 15, 3) on both sides of the
material supply holder. Be careful not to damage
these electrical contacts or the Brady IP printer
will be unable to read the material identification
tag on the labels.
Hay sensores ubicados debajo de las orejas
laterales (Figura 15, 3) a ambos lados del soporte
de alimentación de material. Tenga cuaidado para
no dañar estos contactos eléctricos, de lo
contrario la Brady IP impresora de rótulos
quedará incapacitada para leer la etiqueta de
identificación del material que se encuentra en los
rótulos.
1
2
Figure 15, Material Supply Holder
NOTICE
AVISO
Quick Start Manual
3
3. Electrical contacts
15