Table of Contents
Advertisement
Creating, Printing, and Applying Flagged Labels
When you print labels to the BradyPrinter A5500 printer from your labeling software, the printer does
not immediately print the labels. Instead, the labels are sent to the printer's internal memory.
Follow these tips to achieve a high quality flag label:
•
Kinked or curved wire may cause may cause skewing, end mis-match or bubbling.
•
Hold the wires tight and straight during flagging.
•
Use the correct size label for the wire being flagged.
•
Do not use wire jackets with greasy coatings or the flag will not adhere properly.
•
Inspect the peel plate area—especially below—to ensure there are no stuck labels.
•
Clean rollers to avoid adhesive build-up. See
maintenance recommendations.
On your computer:
1. Design labels on your computer.
If using Brady Workstation the software automatically detects the ribbon and labels installed in
the printer.
2. Send labels to the BradyPrinter A5500 printer with the Print command.
On the BradyPrinter A5500 printer:
1. On the home screen, tap Print Jobs.
2. Tap the check box for a job to select it and then tap Add.
This places the job into the print queue and displays the Printing (Run) screen.
3. Physically insert a cable/wire into the printer jaws to print and apply a flag label.
The display advances automatically to the next label and the counter increments.
BradyPrinter A5500 User Manual
The flagger mechanism contains HAZARDOUS MOVING PARTS,
WARNING!
KEEP FINGERS AND OTHER BODY PARTS AWAY!
Creating, Printing, and Applying Flagged Labels
"Cleaning" on page 39
for cleaning and
General Operation
35
Advertisement
Table of Contents
