Installing An Upgrade - Brady BradyPrinter A5500 User Manual

8. Remove the print head assembly. Make sure that the print head ribbon cable is eased part
way through the cable slot.
9. Remove the strain relief tape (if present) from the print head ribbon cable.
10. Disconnect the print head ribbon cable from the assembly, noting the orientation of the cable.
Note: It is important to note the orientation of the print head ribbon cable when disconnecting to
re-connect it the same way.
To install the new print head assembly:
1. Connect the print head ribbon cable to the assembly, orientating it the same way as it was
when removed.
2. Replace strain relief tape, if it was present while disconnecting, on the print head ribbon cable.
3. Install the print head assembly, ensuring that the print head ribbon cable and connector are
eased back through the cable slot.
4. Using a 5/32" hex key, replace the washer and screw located opposite the printhead mounting
pivot shaft.
5. Using a 7/64" hex key, replace the screw that is located above the print head assembly
stamping.
6. Replace label material and ribbon and close the side door.

Installing an Upgrade

Upgrades to system firmware are made available online.
To upgrade firmware:
1. On a computer, go to www.bradyid.com/A5500.
2. Scroll down to SOFTWARE/FIRMWARE UPDATES and click the link for the most recent
firmware update.
The new page will provide an overview of what is included in the release.
3. Scroll to the bottom of the page and click Begin Download.
4. Save the downloaded file to a USB drive.
5. Connect the USB drive to the USB port on the printer. The printer recognizes the upgrade file
and displays a message on the touch screen.
6. Follow the instructions on the touch screen.
When the upgrade is complete, the printer restarts.
BradyPrinter A5500 User Manual
CAUTION! Do not interrupt printer power during an upgrade.
Maintenance
Installing an Upgrade
52