Haptics "Vibration" Alerts And Blue Led Alerts On Headsets; Order Taking Modes Setup - 3M Drive-Thru G5 Installation Manual

3M™ Drive-Thru System Model G5
i
IMPORTANT NOTE
Press the Lane button to configure Detector #2 on Lane 2.
• For presence type detectors, specify a value for Vehicle Detector #X Minimum (Seconds). Setting a higher number will increase
the customer's wait time, but decrease false detections that could be caused by cars driving over the detector without stopping.
i
IMPORTANT NOTE
When the pulse setting is used, each call must be ended by pressing the page button on the headset.
If you are using a vehicle detector board, the presence or pulse setting should match the dip switch setting on the board.
If the vehicle detector is set to delay (via its own dip switches) and you set a delay in the Basestation, the delays are additive: you
could end up with a longer than expected total delay.
L. Haptics "Vibration" Alerts and Blue LED Alerts on Headsets
These options enable the G5 Headset to signal when a vehicle is detected at the order point by:
• Gently vibrating
• Flashing a Blue LED (at the tip of the microphone boom)
These options are, by default, set to YES.
This option only applies to G5 Headsets. If you currently have no G5 Headsets and only XT-1 Headsets, then enabling or disabling this option
will not affect the normal functioning of the XT-1 Headset.
Haptics "Vibration" Alerts on Headsets
Perform the following procedure to enable or disable the Haptics "Vibration" Alerts on the Headset upon a vehicle detect at the order point.
• Enter the Basestation configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Change the value for 07 Global Settings > Vibe Alerts on Headsets to YES or NO.
Blue LED Alerts on Headsets
Perform the following procedure to enable or disable the Blue LED Alerts on the Headset upon a vehicle detect at the order point.
• Enter the Basestation configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Change the value for 07 Global Settings > Blue LED Alerts on Headsets to YES or NO.
M. Order Taking Modes Setup
Perform the following procedure to enable or disable some of the seven different order taking modes from appearing on the Run Menu:
• Enter the Basestation configuration modemode (see "Enter Configuration Mode" on page 28), see "Enter Configuration Mode" on
page 28, and choose 1 System Menu.
• Navigate to 09 O.T. Modes Setup.
• Change the value for each of the following options to Yes or No:
• Manual Listen/Push To Talk
• Manual Listen/Manual Latching Talk
• Auto Listen/Push To Talk
• Auto Listen/Manual Latching Talk
• Hands Free
• Outside
• Always On (Bypass Vehicle Detector)
(Press the directional arrows to scroll up and down the list)
i
IMPORTANT NOTE
Order-taking modes are described in the Operation section.
3M recommends you do not set up more than three order taking modes.
Installation Instructions G5 - Revision C, September 2019
Installation Instructions G5
Revision C, September 2019
41