Change Basic Volume Settings - 3M Drive-Thru G5 Installation Manual

3M™ Drive-Thru System Model G5
Menu
- PAGE Messages Can Cross Lanes?
- Order Point TALK With No Vehicle
- "Pull Ahead" Prompt (Tandem ONLY)
- Vehicle Detector #1 Type
- Vehicle Detector #2 Type
- Vehicle Detector #1 Minimum
- Vehicle Detector #2 Minimum
- Auto Un-Mute HS Mic in Hfree Mode
- External Audio-In Routing Mode
- Ext. Audio-In Gate Threshold Level
- Mute External Audio-In When Busy
- Kitchen Noise Reduction
- Haptic Alerts on Headsets
- Blue LED Alerts on Headsets
- 08 Headset Setup
- 09 O.T. Modes Setup
- 10 Site Scheduling
- 11 Site Information
- 12 Digital IO Setup
- 13 Change Passwords
- 14 Installer Setup
- 15 Factory Setup
- 16 Network Settings
- 17 Reboot System
- 18 Revision Levels
Greeter Menu
H. Change Basic Volume Settings
i
IMPORTANT NOTE
All volume settings should be adjusted during normal or peak business hours. Adjusting them during slow times will likely produce
volume settings that are too low.
i
IMPORTANT NOTE
Inbound and outbound are always defined from the perspective of the headset.
Inbound Microphone Volume
Changing the inbound microphone volume affects the sound volume coming from the customer order point microphone.
To turn up or down the inbound microphone:
• Enter the configuration mode (see "Enter Configuration Mode" on page 28), and choose 1 System Menu.
• Select a new value for 01 Drivethru Volume > Inbound Microphone Volume. The range is 0 (silent) to 20 (max).
Installation Instructions G5 - Revision C, September 2019
Available on Lane 1 Available on Lane 2
Yes No
Yes No
No Yes
Yes No
No Yes
Yes No
No Yes
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Installation Instructions G5
Revision C, September 2019
33