Install The Order Point Speaker And Microphone Assemblies - 3M Drive-Thru G5 Installation Manual

3M™ Drive-Thru System Model G5
XT-1 6-Slot or 3-Slot Battery Charger
Perform the following steps to install and use the 6-slot or 3-slot battery charger (see Figure 7).
• Select a placement location:
• A flat, dry surface such as a desktop or shelf.
• An easy-to-reach wall location if you have the optional wall-mount bracket.
• The power cord should be in a place where it cannot be pinched or bent
• Install the wall-mount bracket on the wall, if applicable.
• Place the charger on the wall-mount bracket or surface.
• Connect the power supply transformer between the wall receptacle and the charger. The charge indicator lights will flash.
• Insert each battery to be charged into a slot on the charger. The charge indicator lights for each slot will light steadily red to indicate
that the battery is charging, or green to indicate that the battery is fully charged.
• When charging is complete, the batteries are ready for use.
i
IMPORTANT NOTE
A fully discharged (dead) battery can take as long as 3 ½ hours to recharge. Fully charged batteries should be stored whenever they
are not in use. Leaving them on the charger does not harm them or waste energy.
E. Install the Order Point Speaker and Microphone Assemblies
Use the recommended speaker and microphone systems listed below and follow the included instructions:
• 3M™ Speaker Assembly, Duplex, 5 inch. Part # 78-6911-4411-3 / 7100133192 (for shallow installations)
• 3M™ Speaker Assembly, Duplex, 4 in 78-6911-5202-5 / 7100114050 (preferred)
• 3M™ Microphone, Duplex, Foam block assembly 78-6911-5201-7 / 7100114046
• 3M™ Microphone, Duplex, With Bracket 78-6911-4400-6 / 7000031016
For information on wiring the speaker and microphone to the base station, see "Basestation-to-Component Wiring" on page 20.
i
IMPORTANT NOTE
Using heat-shrinkable crimp caps, solder and insulate all connections including loop, microphone and speaker.
When using Part # 78-6911-4400-6 and Part # 78-6911-4411-3 for Microphone and Speaker respectively, it is recommended that
the two be acoustically separated by treating the speaker post with the 3M Acoustic Kit.
For more information refer to "Appendix: 3M™ Acoustic Kit Installation Guide" on page 63.
12
Figure 7.
Installation Instructions G5 - Revision C, September 2019