3M Drive-Thru G5 Installation Manual page 7

3M™ Drive-Thru System Model G5
FCC and IC Identifiers:
XT-1 Headset:
FCC ID: DGFBCSDXT1H
IC ID: 458A-BCSDXT1H
G5 Basestation Model G5B1:
FCC ID: DGFBCSDG5B1
IC ID: 458A-BCSDG5B1
3M™ Drive-Thru Headset G5:
FCC ID: DGFBCSDG5H1
IC ID: 458A-BCSDG5H1
i
IMPORTANT NOTE
Modifications to this device shall not be made without the written consent of 3M Company. Unauthorized modifications may void
the authority granted under Federal Communications Commission Rules and Industry Canada Rules permitting the operation of
this device.
Recycling / Disposal (Notice to European Union customers)
These products must be disposed of or respectively recycled at the end of their lifetime according to
the till then mandatory laws and rules.
Under European Union ("EU") Directive on Waste Electrical and Electronic Equipment, Directive
2012/19/EU products of electrical and electronic equipment cannot be discarded as municipal waste,
and manufacturers of covered electronic equipment will be obligated to take back such products at the
end of their useful life. For appropriate disposal and recycling instructions, contact your local 3M
representative.
European Union CE Information
i
IMPORTANT NOTE
To ensure that the maximum 20 dBm EIRP output power is not exceeded for any 3M-approved external antenna that is used with the
G5 Basestation Model G5B1, the minimum length of RF cable required is 100 feet.
6
Installation Instructions G5 - Revision C, October 2019