Haptics "Vibration" Alerts And Blue Led Alerts On Headsets; Haptics "Vibration" Alerts On Headsets; Blue Led Alerts On Headsets; Order Taking Modes Setup - 3M G5 Operating Instructions Manual

Haptics "Vibration" Alerts and Blue LED Alerts on Headsets

These options allow you to enable the G5 headset to
when a vehicle is detected at the Order Point
These options are, by default, set to YES.
This option only applies to G5 headsets.
If you currently have no G5 headsets and only XT-1 headsets, then enabling or disabling
this option will not affect the normal functioning of the XT-1 headset.
Important Notes:
G5 Headsets are backward compatible with Basestation software versions 5.12 and lower,
however, the Blue LED Alert and Haptics "Vibration" feature will not be available on these
basestation software versions.
The Blue LED Alert and Haptics "Vibration" Alerts are only available in Basestation
software 6.x or greater.
In order to have this feature, you will need to conduct a Basestation software upgrade for
which you will need to purchase the following kit:
XT-1 Basestation Software Update Kit XT-1
The Software upgrade kit consists of :

Order Taking Modes Setup

3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
- Gently vibrate and/or
-Flash a Blue LED (at the tip of the mic boom)
-An installation CD (including the Install program , basestation software files, and
manuals) and the
- USB cable.

Haptics "Vibration" Alerts on Headsets

Perform the following procedure to enable or disable the Haptics "Vibration" Alerts
on the Headset upon a vehicle detect at the Order Point
•
Enter the base station configuration mode, see page 11.
•
Change the value for
Headsets

Blue LED Alerts on Headsets

Perform the following procedure to enable or disable the Blue LED Alerts on the
Headset upon a vehicle detect at the Order Point
•
Enter the base station configuration mode, see page 11.
•
Change the value for
Alerts on Headsets
Perform the following procedure to enable or disable some of the seven different
order taking modes from appearing on the Run Menu:
•
Enter the base station configuration mode, see page 11.
•
Navigate to
•
Change the value for each of the following options to
•
Manual Listen/Push To Talk
•
Manual Listen/Manual Latching Talk
•
Auto Listen/Push To Talk
•
Auto Listen/Manual Latching Talk
78-6911-4957-5
07 Global Settings
to or .
YES NO
07 Global Settings
to or .
YES NO
09 O.T. Modes Setup
November 6 2014 – Revision 2.1
Configuration
>
Vibe Alerts on
>
Blue LED
.
or :
Yes No
Page 25 of 77