Chapter 1: Introduction And Specifications; Spectracomm Srm-6 Overview; Intended Use; Features & Benefits - General DataComm SpectraComm SRM-6 Installation & Operation Manual

Subrate multiplexer
Table of Contents

Advertisement

SpectraComm SRM-6 Overview

The SpectraComm SRM-6 is a six-channel Time-Division Subrate Multiplexer that interfaces with
a SpectraComm V.F28.8/33.6 modem, a SpectraComm 521A/S DDS DSU, a SpectraComm 553 T1
DSU, or any RS-232 or RS-530 DCE device in point-to-point applications. A SpectraComm
Manager (SCM) card provides the Telnet and Ethernet connections. Field personnel can attach a
VT100/ASCII terminal to the SCM craft port to provision the SRM-6, monitor alarms and status,
and perform diagnostics and maintenance. The SCM is the SNMP proxy agent for the SRM-6 and
the modem/DSU, allowing alarm traps sent to a trap manager.

Intended Use

The SRM-6 installs in one slot of a SC 2000 low density shelf or a SC 5000 high density shelf. The
SRM-6 front panel provides LEDs that indicate operating status. The mass termination connector
at the front panel is cabled to an accessory panel which provides six EIA-232-E interfaces through
DB-25 Female connectors wired as DCE. The accessory panel mounts onto the rear of the SC 2000
shelf or can be installed at the front of the telco rack. Refer to
paragraphs for complete front and rear panel connection instructions.
Features & Benefits
Provides efficient, cost-effective network access for subrate applications by reducing the need
for additional communication lines and equipment.
Combines synchronous and asynchronous data from up to six subrate users into one TDM
payload.
Allows users' mixed data rates in one TDM payload.
Built-in diagnostic aggregate loopback (toward DTE)
Alarm monitor and SNMP trap generation
Telnet, LAN, and ASCII/VT100 craft connections
via the SCM
Multi-level password protection for craft or Telnet management access; inactivity timers.
Front Panel LEDs indicate operating status
TFTP download for firmware upgrades
Power requirements are less than 6 Watts per card.
076R176-000
Issue 1
Introduction and
Chapter 1:
SC SRM-6 Multiplexer
Installation & Operation Manual
Specifications
Figure 2-2
and accompanying
1-1

Advertisement

Table of Contents
loading

This manual is also suitable for:

076p054-001

Table of Contents