Table of Contents
Advertisement
Installation and Setup
Configuring a Telnet Connection
You can access the terminal interface through a Telnet connection via the SCM LAN port.
One SCM supports a terminal interface for up to 15 units in a single SC5000 shelf. A management
session is active as soon as a valid login sequence is completed.
Making a Telnet Connection
1. Establish a Telnet connection to the SCM using a PC. Refer to the SpectraComm Manager
Card Installation and Operation Manual as needed. When connection is made, the following
screen appears.
Copyright (c) 2004 General DataComm Industries Inc.
All rights reserved
SCM Application Version 5.80
login:
2. Enter the login password (scmadmin).
Note
There is a 10-minute timeout programmed at the terminal interface. If you allow 10 minutes to pass with no
activity, that is without pressing any key on the keyboard, the unit will terminate the session.
3. After the SCM verifies the login password, the Shelf Inventory screen appears
This is the point of access for any network element via its shelf slot number.
Note
The SCM will display an alarm tag at the slot of any device with an alarm condition in effect.
Figure 2-3
4. Select a slot number to access the terminal interface of the SRM-6 or other device, and then
press Enter. The Main Menu appears for the selected device appears.
5. For a description of all SRM-6 menu items, refer to Chapter 3, SRM-6 Operation &
Diagnostics . For other elements in the shelf, refer to the associated manuals.
2-12
SHELF INVENTORY
Slot
Card
--------------------------------------------------
[1] SCM
[2] VF288 (alarm)
[3] SCSRM6
[4]
[5]
[6]
[7]
[8]
[9]
[10]
[11]
[12]
[13]
[14]
[15]
[16]
[0] Close Session
Enter slot number:
Shelf Inventory Screen
SC SRM-6 Multiplexer
Installation & Operation Manual
Slot
Card
[C] Circuit Identification
[
]
Accessing the Shelf
(Figure
2-3).
076R176-000
Issue 1
Advertisement
Table of Contents
