Table of Contents
Advertisement
Chapter 2:
Installation Overview
This chapter describes setting options and installing the SRM-6 card and the two companion cards
(SCM and modem or DSU). These devices are intended for rack-mount installation in two linked
SC2000 shelves, or in any slot of the SC 5000 shelf. For more information on these SpectraComm
shelf systems, refer to the manuals listed on the inside front cover of this manual.
Unpacking Instructions
Device cards are shipped in shock-absorbent packing within a corrugated box.
Table 2-2
list the standard and optional equipment and shelf systems. Some components will not be
required/supplied for your network installation. Remove each component from the box and perform
a thorough inspection. If any component appears damaged, contact the shipper immediately. All
damaged components must be retained until an inspection by the shipper has been completed. If it
is necessary to re-package and return the unit, use the original box and packing material.
Table 2-1
Equipment Checklist
Item
Description
SRM-6
SpectraComm Subrate Multiplexer Card
SCM
SpectraComm Manager Card (Firmware Ver 5.91 or higher)
SC V.F28.8/33.6
SpectraComm V.F28.8/33.6 Switched Network/Private Line Card
SC 521A/S
SpectraComm 521A/S DDS Data Service Unit
SC 553
SpectraComm 553 T1 Data Service Unit
SpectraComm 553 T1 Data Service Unit with Cascade
Filler Panel
Blank panel used to cover unused cards slots in the shelf
DCE Cable
RS232/530 Shielded straight-thru male to male (mux to modem/DSU)
DTE Cable
RS232 shielded straight-thru male to male (DTEs to DTE Access Panel)
DTE Cable
RS232 shielded straight-thru male to female (DTEs to DTE Access Panel) 028H506-XXX
DTE Cable
64-pin amp type Telco to blunt end
DTE Access Panel
Rear-mounting SC 2000 shelf patch panel
(SRM-6 to six female DB25 connectors)
DTE Access Panel
Front mounting SC 2000/SC 5000 shelf patch panel
(SRM-6 to six female DB25 connectors)
LAN Cable
SCM LAN 10BaseT
Craft Cable
RJ-45 to RJ-45, local control (SCM CTRL port): 7', 14' or 25'
Mngt Link Cable
3-pin share jumper (Shelf-to-shelf management link)
Adapters
DB9F to RS561 8-pin modular jack (SCM to PC terminal)
RS232-RS561 DB25 male to RJ45 (SCM to PC terminal)
076R176-000
Issue 1
Installation and Setup
SC SRM-6 Multiplexer
Installation & Operation Manual
Table 2-1
and
Part Number
076P054-001
058P150-002
060M012-001
076P028-001
076M016-010
076M016-011
010P142-001
028H502-005
028H502-XXX
021H700-XXX
010B048-002
010B048-003
029H209-001
830-128-807
024H218-001
029H211-001
029H210-001
2-1
Advertisement
Table of Contents
