General Cleaner Operation; Install And Submerge The Cleaner - Zodiac EvoluX iQ Series Owner's Manual

Robotic pool cleaner
Table of Contents

Advertisement

X
NOTE: To avoid damaging the power cable, do not
try to twist the entire cable housing (see below).
X
NOTE: To avoid exposing the power cable
connector pins to water, be sure the connector is
screwed in all the way and there is no gap
(see below).
X
4
General Cleaner
Operation
CAUTION
To prevent damage to the cleaner, be sure to adhere
to the following guidelines:
Remove the cleaner from the pool after the
cleaning cycle is completed.
Store on the caddy out of direct sunlight or
inclement weather.
Never lift the cleaner out of the pool by the
floating cable. Always use the lift feature to
remove cleaner from the pool.
Take additional care when lifting the cleaner out
of the pool. It becomes heavier when filled with
water.
Always remove the cleaner from pool when super
chlorinating or adding acid.
Do not handle cleaner while it is in operation
Zodiac
EvoluX
iQ Robotic Pool Cleaner
®
X
X
|
Owner's Manual
Always make sure the cleaner head is fully
submerged before you begin operation.
Clean the filter canister after each cleaning
cycle.
Do not leave your cleaner in the pool on a
permanent basis.
At the end of each cycle, remove the cleaner
from the pool.
Start at the cleaner head and untangle any
coils in the cable before storing the cleaner.
The Evolux robotic cleaner includes a safety
feature that automatically stops the cleaner if it is
X
powered on but not submerged in water. For pools
equipped with a beach area, this safety feature is
programmed to drive the cleaner in reverse and
back into the pool when the impeller is out of the
water.
Zodiac recommends not exceeding 3 cleaning
cycles per week.

Install and Submerge the Cleaner

1.
With the control box plugged into a power
outlet, spread the floating cable across the
pool deck until you reach the middle of the
pool length.
2.
At the center point, submerge the cleaner
in the pool and hold in the vertical position
to release any air trapped inside. (Figure
12).
1
Figure 11. Submerge the Cleaner Vertically
IMPORTANT
X
Page 9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Evolux ex4000 iqEvolux ex5000 iqEvolux ex6000 iq

Table of Contents