Dismissing An Error Code; Iaqualink Troubleshooting - Zodiac EvoluX iQ Series Owner's Manual

Page 24
User Issue
The cleaner is not cleaning
the pool effectively.
Pool temperature reading
from the cleaner (certain
models only) is different to
the temperature reading
shown in the iAquaLink app
or other equipment.

Dismissing an Error Code

From the Control Unit:
After you have completed the troubleshooting solution steps, press any key (except the phone icon) to
clear the error code.
If the control unit is in Standby Mode, press the Start/Stop button to show the on-screen display. After
you have completed the troubleshooting solution steps, press any key (except the phone icon) to clear
the error code.
From the iAquaLink
™
Press the error icon to display troubleshooting solutions. After you have completed the troubleshooting
solution steps, press Clear Error to return to normal operation. Or, press OK if you need to complete the
solution steps at a later time.

iAquaLink Troubleshooting

This information can help to troubleshoot connection and setup challenges between the iAquaLink app
and the cleaner.
How It Works
Your
Smart
Device
Internet
Zodiac
®
Possible Cause
Filter canister is full or dirty.
Brushes are worn.
Cable is excessively tangled.
The cleaner reading is taken from the
bottom of the pool. Deeper water will
be colder than at the waterline.
App:
Your
Internet
Router
EvoluX iQ Robotic Pool Cleaner
™
Dispose of debris and thoroughly clean the filter
canister with mild soap and a soft brush. Then,
re-submerge the cleaner (see: Clean the Filter
Canister).
Check the wear indicator(s). Contact your local
dealer for spare parts.
Untangle the twisted cord and lay in sun to
reduce memory. (See: Cord Tangling).
Take an average of the two readings to
approximate current pool water temperature.
Cleaner
Control
Unit
|
Owner's Manual
Suggested Solution
Robotic
Pool
Cleaner