Warranty - Kasco VFX Series Owner's Manual

• Single phase aerators are supplied with an internal grounding conductor and/or a grounding-type attachment plug. To reduce the
risk of electrical shock, be certain the aerator is properly connected to the
Kasco supplied control panel. (refer to the C-25,
C-85 & C-95 Control instructions)
•
3 phase aerators (2.3VFX, 5.3VFX) require a startup test after wiring to ensure proper rotation of the propeller. If the propeller is
rotating in the opposite direction, the unit will not perform properly and internal damage to the unit may occur. (See 3 phase startup
procedure)
•
Control panels must be installed a minimum of 5ft(3m in Canada) from the inside wall of the pond, unless separated from the body of
water by a fence wall, or other permanent barrier that will make the unit inaccessible to persons in the water.
•
Control panels must be installed by a qualified electrician.
• Ground Fault Circuit Interrupters (GFCI) should be tested upon each installation and every month thereafter to ensure proper
operation.
INSPECT THE SHIPMENT
Immediately inspect your Kasco Aerator shipment for any visible damages. Also cross reference the parts supplied with the Parts
Included sheet to check for shortages. Shortages should be reported immediately to your Kasco Marine distributor or representative
and damages reported to your carrier and Kasco Marine.
CAUTION
WARNING: Under NO circumstances should anyone enter the water with the unit in operation. Always operate the unit in the water
and keep people and objects clear of the propeller. Do not lift or pull the unit by the electrical cord. Always use extreme caution
around electrical equipment and water situations.
ASSEMBLY & INSTALLATION
Please see the proper Assembly and Installation Instructions enclosed in this manual. Each is specific for your model and size of
aerator. Note: Use a nylon tie to help keep the power cords for the unit and lights free of the propeller by tying each cord to either side
of the float. If you have a light kit, make sure that the unit cord is tied to one side of the float and the light cord to the other for balance.
Note: It is extremely important to test the GFI breaker in the control panel upon each installation/reinstallation of the unit to ensure
proper functioning.

WARRANTY

Kasco aerators are the result of over 35 years of design and engineering. Kasco products are built to withstand the toughest
conditions. Kasco Marine backs each VFX model aerator with either a 2 Year or 3 Year Warranty depending on the model. This
warranty covers any and all manufacturers defects within the warranty period from the date of purchase (See Warranty Section).
USE AND OPERATION
Kasco aerators are designed and engineered for continuous duty, such as on fish farms or other aquaculture applications, or on-
demand use, as needed in a recreational water feature. During flotation operation, the water is pulled from 360 degrees around the unit
and from below the unit. The water is pulled upward and thrust through the flotation collar into the air. Your Kasco Marine aerator is
ready for immediate use (after installation). Make sure to keep the motor housing clean from hard water deposits and/or algae. (See
Maintenance Recommendations.) It is extremely important that proper and sufficient voltage is supplied to the aerator motor. Unit
should be protected by a GFCI. Control panels must be installed by a qualified electrician. (See Installation instructions).
UNIT STORAGE
When storing units during the offseason, it is important to store them upside down if they are going to be sitting for long periods of time.
Units that sit upright on a shelf for many months, or even years have a greater likelihood of seals drying out. Storing upside down will
ensure oil is lubricating the seals and prevent drying.
General Owner's Instructions