For United Kingdom Only - Exido 245106 Manual

Anti boil-dry device
If you switch the appliance on without
having filled it with water, or when the
water level is below the "MIN" mark, the
anti boil-dry device will automatically
switch it off. The appliance can be
switched on normally as soon as it is
filled with a sufficient amount of water.
CLEANING
When cleaning the appliance, you
should pay attention to the following:
• Remove the plug from the mains
socket, and allow the appliance
to cool down completely before
cleaning it.
• Never submerge the appliance
base, cord or plug in water, and no
water must be allowed to enter the
appliance base.
• Clean the appliance and base by
wiping with a damp cloth. A little
detergent can be added if the
appliance is heavily soiled.
• Do not use scouring pads, steel
wool or any form of strong solvents
or abrasive cleaning agents to
clean the appliance, as they can
damage the external surfaces of the
appliance.
• Remove the limescale filter (1) from
the appliance and carefully clean it
with a soft brush. Remove the filter
by pulling it upwards and out of
the holder. Replace the filter in the
appliance after cleaning.
• IMPORTANT! Allow the appliance to
dry fully after cleaning before using
again. The appliance must not be
used if the base or the underside of
the appliance is wet.
• Ensure the appliance is clean and
dry before storage.
DESCALING
The lime content of ordinary tap water
means lime scale may gradually be
deposited inside the appliance. This
lime scale may be loosened using acetic
acid (NOT ordinary vinegar) or descaler,
available in supermarkets, etc.
1. Mix 100 ml acetic acid with 300 ml
cold water, or follow the instructions
on the descaler packaging.
2. Pour the solution into the appliance
and switch on using the On/Off
button.
3. Boil until the appliance switches off
automatically.
4. Leave the solution in the appliance
for approx. 10 minutes before
emptying.
5. To remove the last residues of
lime scale and acetic acid, fill the
appliance with fresh cold water
and boil. Do this three times. The
appliance is now ready for use.

FOR UNITED KINGDOM ONLY

Plug wiring:
This product is fitted with a BS 1363
13-amp plug. If you have to replace the
fuse, only those that are ASTA or BSI
approved to BS1362 and with a rated
current of 13 amps should be used. If
there is a fuse cover fitted, this cover
must be refitted after changing the fuse.
If the fuse cover is lost or damaged, the
plug must not be used. You must also
check if the socket outlets in your home
fit with the plug of the appliance. If the
socket outlet in your home does not fit
with the plug, the plug must be removed
and disposed of safely as insertion of
the plug into the socket is likely to cause
electric hazard. A replacement plug
should be wired according to following
description.
25