Advertisement
SOLDERING IRON DIGITAL TEMP CALIBRATION
By default, the system is properly calibrated but for cases when a little adjustment of the soldering iron
calibration is required the following procedure can be done.
1.
Turn on the soldering iron function switch.
2.
Set to appropriate temperature you want to calibrate. Place the tip of the soldering iron on an
external temperature sensor.
3.
The readings on the external temperature sensor should be more or less equal to the dis-
played temperature.
4.
If there are large discrepancy in the temperature reading we can re-calibrate the temperature
setting.
5.
While the solder iron is operating make sure the hot air gun and Preheating function is in off
mode ("0FF" is displayed on the panels "1" and "2"), hold the preheater UP button for a few
seconds until four zeroes are displayed "0000" .
6.
Adjust the temperature compensation using the UP and DOWN buttons of the Soldering iron
adjustment buttons.
A zero "0" on the first digit signifies addition to the current temperature and a minus "-" on the
7.
first digit will subtract the displayed value from the current settings.
8.
Confirm the change by pressing the air pressure down button.
EXAMPLE:
•
The external temperature sensor displays 248 to 252 degrees.
•
The set temperature and displayed actual temperature of the soldering iron is 300 degrees.
•
300 — 248 = 52. An additional adjustment of 52 degrees is required.
•
Enter calibration mode.
•
Increase from "0000" to "0052".
•
Exit calibration mode.
•
The external temperature sensor would now display 298 to 302 degrees.
NOTES:
•
The calibrated data is saved into the memory and shall remain effective until it is recalibrated
again or new data is entered.
•
Calibration will only make the newly calibrated point the most accurate. Other temperature
points may be a little off.
•
The soldering Iron has a lowest temperature limit such that when the temperature has been
set to 200 degrees with external actual temperature also showing 200 degrees, further de-
creasing the temperature offset would be only have minimal effect to the actual temperature.
CARE and MAINTENANCE
SOLDERING IRON TIP
Always keep the solder-plated section of the tip/nozzle coated with a small amount of solder. Oxide
coating on the tip of the nozzle reduces its heat conductivity. Coating the tip with a small amount of
fresh solder ensures maximum heat conductivity is obtained.
SOLDERING IRON ERROR MESSAGES
1.
Soldering Iron connection assembly is not connected or not properly con-
nected to the receptacle on the control panel.
2.
Soldering iron tip is damaged and needs to be replaced. The device will dis-
play "PLUG".
3.
This is indicating a problem with the contacts of the soldering iron or the tip.
© by WilTec Wildanger Technik GmbH
http://www.aoyue.eu
http://www.wiltec.de
http://www.teich-tip.de
Seite 34
Advertisement
