Advertisement
OPERATING GUIDELINES
IMPORTANT:
1.
The device should be placed on a stable surface and all components that generate heat
should be placed in the holders provided for this purpose.
2.
All switches should be set to OFF before starting work.
3.
All connections must be secured.
IMPORTANT: For indicators and keys, see Control Panel Guide.
A.
INITIAL PROCEDURES
1.
Plug the device to the main power source using the power cord provided in the package.
2.
With all function switches deactivated and all terminal connections properly secured, switch
ON the device by activating the main power switch located at the back of the unit.
3.
The display panels, will temporarily show the product name in a scrolling manner and then
display "OFF" on all rows once the scroll is finished (see below illustration). The system will
remain at this state until the user activates a function.
B.
CELCIUS TO FAHRENHEIT SWITCHING
1.
Plug the device to the main power source using the power cord provided in the package.
2.
Press and hold the solder iron UP button while turning on the system power to set system to
Centigrade mode. The display will show "Aoyue 866C" with the last character indicating the
type of temperature scale used. "C" Centigrade, "F" Fahrenheit.
3.
Press and hold the solder iron DOWN button while turning on the system power to set system
to Fahrenheit mode. The display will show "Aoyue 866F" with the last character indicating the
type of temperature scale used. "C" Centigrade, "F" Fahrenheit.
C.
HOT AIR GUN
Follow the initial procedures above, "A. INITIAL PROCEDURES".
1.
2.
Adjust Hot Air Gun Airflow Adjustment to the middle position.
Activate "Hot Air Gun" switch ("9" from the control panel).
3.
4.
The system will immediately start to blow air at a medium airflow while rapidly and safely in-
creasing the air temperature to 100°C (default system operating parameters). These values
will be reflected from the Hot Air Gun Air Temperature display panels, "1" from the control
panel, respectively.
5.
Adjust to desired air flow.
6.
Adjust the hot air gun temperature using the HOT AIR GUN TEMPERATURE ADJUSTMENT
BUTTONS ("4" from the control panel). The prefix of the display for Hot Air Gun Temperature
will change from "H" to "h" indicating that air temperature is being adjusted. It will return to "H"
(indicating actual temperature) while the temperature is gradually increasing or decreasing un-
til the desired temperature is reached.
IMPORTANT: When adjusting the air temperature, it is strongly advised to initially in-
crease the airflow level in order to manage the system temperature. This is to protect
the heating element inside the handle from excessive heat and avoid possibility of sub-
jecting adjacent components to thermal shock.
7.
Reworking task can be started 1 minute after the desired hot air temperature and airflow level
are reached, as also indicated from display panel "1".
8.
When reworking is complete, return the Hot Air Gun to its holder and DO NOT immediately
turn off the main power switch.
© by WilTec Wildanger Technik GmbH
http://www.aoyue.eu
http://www.wiltec.de
http://www.teich-tip.de
Seite 31
Advertisement
