Advertisement
B.
Soldering Iron
Follow instructions on "Soldering Iron Stand Assembly guide".
1.
2.
Connect the cable of the soldering iron to the output terminal located in the middle of
the lower part of the device.
3.
Place the soldering iron in the holder.
C.
Pre-Heater
1.
Screw in PCB-Holder using securing screw on desired position.
2.
Adjust multipurpose PCB-Holder to accommodate PCB shape.
D.
Hot Air Gun
To set up the Hot Air Gun Stand:
1.
Use the 8 mm screw to secure the holder to the station.
2.
Place the hot air gun onto the stand in preparation for usage.
© by WilTec Wildanger Technik GmbH
http://www.aoyue.eu
http://www.wiltec.de
http://www.teich-tip.de
Seite 29
Advertisement
