Advertisement
AUTO SLEEP FUNCTIONS
AUTO-SLEEP MODE (Hot Air Gun)
The device has a built-in auto-sleep mode feature such that if there has been no user input from the
hot air gun temperature adjustment button for 30 minutes (default) or the Hot Air Gun remained unat-
tended, the device will switch to sleep mode. The system will blow air (at room temperature) at maxi-
mum rate in order to bring down the temperature. Once the temperature drops to approximately 90°C,
the Hot Air Gun will automatically stop and show an all-dash " - - - - " display indicating that the system
is now on sleep mode.
CHANGING SLEEP MODE TIMER (Hot Air Gun)
By default, the system has 30-minute countdown time before the hot air gun goes to sleep mode. This
can be altered by the following procedure.
While the hot air gun is on stand-by mode ("0FF" is displayed on the panel "1"), hold both UP
1.
and DOWN buttons of the HOT AIR GUN TEMPERATURE adjustment buttons.
Wait until "t030" is displayed on the Hot Air Gun Temperature display panel, "1".
2.
Release the buttons when "t030" appears.
3.
4.
Adjust the time using the same UP and DOWN buttons of the HOT AIR GUN TEMPERATURE
adjustment buttons.
5.
Confirm the change by activating the HOT AIR GUN function switch.
6.
The system will immediately switch back to operation and use the defined countdown parame-
ter for the entire usage.
NOTES:
•
The sleep mode timer is configurable between 1 and 30 minutes. Sleep mode settings for Hot-
Air gun and Soldering Iron are saved into the memory and shall remain effective until it is res-
et or new data is entered.
AUTO-SLEEP MODE (Soldering Iron)
The soldering iron's SLEEP mode is deactivated by default. Follow the set of procedures below to
activate this feature.
CONDITION:
SOLDERING IRON function is inactive.
While soldering iron is displaying "OFF" or in stand-by mode, push both UP and DOWN but-
1.
tons of the SOLDERING IRON TEMPERATURE adjustment buttons ("6" from the CONTROL
PANEL GUIDE page).
Wait until "t0FF" appears from soldering iron temperature display panel. This means sleep
2.
mode is currently turned OFF.
3.
Release the two buttons after the change in display.
Use the same two buttons to adjust the countdown time. "t001" means solder iron will go to
4.
sleep in 1 minute. Timer is adjustable from 1 to 60minutes.
5.
Confirm the change by activating the SOLDERING IRON switch.
To DEACTIVATE this feature, simply follow the above procedures. This time, select "tOFF".
6.
During sleep mode, the soldering iron temperature display panel will show an all-dash, "- - - -".
7.
8.
To wake the soldering iron from sleep mode, press the soldering iron temperature adjustment
buttons.
© by WilTec Wildanger Technik GmbH
http://www.aoyue.eu
http://www.wiltec.de
http://www.teich-tip.de
Seite 33
Advertisement
