Figure 5-30 Gad 29B Interface To Cessna Autopilots, Sheet 2 Of 2 - Garmin G5 Installation Manual

Figure 5-30 GAD 29B Interface to Cessna Autopilots, Sheet 2 of 2

5.23.2.1 G5 Configuration Cessna Autopilots
Note: The Flight Controls Configuration shown below only needs to be set on the master G5. In a
single installation the master is the only G5 indicator installed. In a dual installation the master is the G5
Attitude indicator.
Config
Page Config Option
Flight Analog Autopilot
Controls Interface
GPS Steering*
GPSS Scale
Factor*
* GPS Steering and GPSS Scale Factor is configured the same for all listed Analog Autopilot interfaces
** If the autopilot does not turn tightly enough while roll steering, increase the GPSS Scale Factor setting. If the
autopilot turns too tightly while roll steering, decrease the GPSS Scale Factor setting.
Garmin G5 Electronic Flight Instrument Part 23 AML STC Installation Manual
Configuration Setting
AP Model G5 Config
Cessna 300 IFCS Cessna 300 (AC)
Cessna 400 & 800 Cessna 400 (AC)
IFCS
Cessna 300B Cessna 300 (DC)
IFCS
Cessna 400B & Cessna 400 (DC)
800B IFCS
Enabled
1.00**
This area intentionally blank
Page 187
Interfacing Equipment
Configuration Information
Cessna A/P Config
As per wiring interface in
Figure 5-29 & Figure 5-30
---
190-01112-10
Rev. 21