Garmin G5 Installation Manual page 124

Config Page
Navigation
Units
RS-232
ARINC 429
Exit Configuration Mode
GNC 255 Configuration
5.7.2
Config Page
Sys Configuration
NAV Configuration
SL30 Configuration
5.7.3
Config Page
Sys Configuration
Attitude Configuration
Note 1: Set configuration values and units to match the values indicated in the appropriate AFM and
document settings in the space provided.
Note 2: If the aircraft has no AFM set the values as determined by the existing placards, instrument bugs
or instrument markings.
Note 3: Existing placards related to airspeed limitations must be retained.
Note 4: Setting can remain at default setting, not supported in this configuration.
Note 5: The "Selected Course" will display when only one navigator is interfaced to the G5.
Note 6: "Selected Course 1" and "Selected Course 2" will display when dual navigators are interfaced. If
GNC255/SL30 is navigator #1, "Selected Course 1" is set to "Enabled". If GNC255/SL30 is
navigator #2, set "Selected Course 2" to "Not Enabled".
Garmin G5 Electronic Flight Instrument Part 23 AML STC Installation Manual
Config Option
Navigation Data
Selected Course
Selected Course 1
Selected Course 2
VNAV Deviation Scale
Altitude
Distance
Airspeed
Vertical Speed
Pressure
Input Format
Output Format
Output 1
Output 2
Input 1
Input 2
Input 3
Input 4
Config Option
RS 232 Serial Port
CDI Indicator
ARINC 429
Config Option
RS 232 Serial Port
Indicator Type
Page 124
Configuration Setting
Enabled
Note: If an autopilot interface is configured, this
configuration page is set to ENABLED by default.
Enabled (5)
(6)
(6)
(4)
(1)(2)
(1)(2)
(1)(2)(3)
(1)(2)
(1)(2)
Garmin VHF NAV Radio (If GNC is #1 Navigator)
Garmin VHF NAV Radio (If GNC is #1 Navigator)
None
None
None
Garmin VOR/ILS (SDI 1) (If GNC is #1 Navigator)
None
Garmin VOR/ILS (SDI 2) (If GNC is #2 Navigator)
Configuration Setting
IO Mode = NMEA
Serial (If GNC is #1 navigator)
Or
None (If GNC is #2 navigator)
Tx = Low
SDI =
VOR/ILS 1 (If GNC is #1 Navigator)
Or
VOR/ILS 2 (If GNC is #2 Navigator)
Configuration Setting
No Setting
TYPE = Serial
190-01112-10
Rev. 21