Setting The Remote Signal Receiving Function; Disabling Remote Signal Receiving Function Of The Remote Control Unit - Marantz PM6007 Owner's Manual

Contents Connections

Setting the remote signal receiving function

When you connect a IR receiver (sold separately) to the REMOTE
CONTROL IN connector of this unit, use the following procedure to
disable the remote signal receiving function of this unit. When the function
is enabled, you can not perform operations with the remote control unit.
By default, this function is enabled.
SPEAKERS A
Front panel Rear panel
Playback
SPEAKERS B
Remote control 33
unit
Settings
Disabling the remote signal receiving
function of the remote control unit
1
Press SPEAKERS B for approximately 5 seconds to
disable the remote control signal receiving function.
The indicator of the currently set input source flashes in red three
times.
Enabling the remote signal receiving
function of the remote control unit
1
Press SPEAKERS A for approximately 5 seconds to
enable the remote control signal receiving function.
The indicator of the currently set input source flashes in blue three
times.
Index
Tips Appendix