Connecting Speakers; Connecting The Speaker Cables - Marantz PM6007 Owner's Manual

Contents Connections

Connecting speakers

NOTE
0 Disconnect this unit's power plug from the power outlet before connecting the
speakers.
0 Connect so that the speaker cable core wires do not protrude from the speaker
terminal. The protection circuit may be activated if the core wires touch the rear
panel or if the + and - sides touch each other. ("Protection circuit" (v p. 43))
0 Never touch the speaker terminals while the power cord is connected. Doing so
could result in electric shock.
0 Use speakers with impedances within the ranges shown below to suit how they
are used.
Speaker terminals No. of connected
used on this unit
SPEAKERS A
(Standard
connection)
SPEAKERS B
SPEAKERS A and
SPEAKERS B
SPEAKERS A and
SPEAKERS B
(Bi-wiring
connection)
Front panel Rear panel
Playback
Speaker
speakers Impedance
2 (one set) 4 – 16 Ω/ohms
2 (one set) 4 – 16 Ω/ohms
4 (two sets) 8 – 16 Ω/ohms
2 (one set) 4 – 16 Ω/ohms
Remote control
unit
Settings
o Connecting the speaker cables
Carefully check the left (L) and right (R) channels and + (red) and –
(black) polarities on the speakers being connected to this unit, and be
sure to connect the channels and polarities correctly.
1
Peel off about 3/8 inch (10 mm) of sheathing from the tip of the
speaker cable, then either twist the core wire tightly or terminate it.
2
Turn the speaker terminal counterclockwise to loosen it.
3
Insert the speaker cable's core wire to the hilt into the
speaker terminal.
4
Turn the speaker terminal clockwise to tighten it.
16
Index
Tips Appendix