Setting Remote Control Codes; Setting Remote Control Codes For The Remote Control; Setting Remote Control Codes For This Unit; Setting Auto Standby Mode - Marantz PM6004 Owner's Manual

Setting remote control codes

This unit and its supplied remote control are equipped with three sets
of remote control codes. When two or three amplifiers are used in the
same location, you can set a different remote control code to pair each
unit and remote control so that you can operate the selected amplifier
from the remote control without interference from other signals.
• When the unit is shipped from the factory, the main unit and remote
control are set to "AMP1".
[1]
[DISPLAY]
Setting remote control codes for the remote
control
To set the remote control to AMP 2
[AMP] [2]
Press and hold and number button
To set the remote control to AMP 3
[AMP] [3]
Press and hold and number button

Setting remote control codes for this unit

[AMP]
Hold down
• This operation sends the remote control code set for the remote to
this unit.
• After you set the remote control code for this unit, the indicators on
the unit blink as shown below.
AMP1 ： The PHONO indicator flashes three times.
[AMP]
AMP2 ： The TUNER indicator flashes three times.
[2]
[3]
AMP3 ：The CD indicator flashes three times.
for 5 seconds or longer.
NOTE
To restore the remote control code default setting, press and hold
[AMP]
and number button
for 5 seconds or longer.
[DISPLAY]
and press .
[1]
for 5 seconds or longer.

Setting Auto standby mode

With the Auto standby mode ON, this unit will automatically enter the
Auto standby mode after about 30 continuous minutes of no output
from the speakers or headphones.
SOURCE DIRECT
Press and hold <SOURCE DIRECT> for at least 5 seconds.
Auto standby mode is switched between On and Off.
Auto standby mode "Off" Auto standby mode "On"
Power indicator
Flashes once
NOTE
Perform the operation using the buttons on the unit. You cannot
[SOURCE DIRECT]
perform the operation using
• The default setting for the Auto standby mode is OFF.
• This unit will automatically enter Auto standby mode after about
continuous 30 minutes in the following conditions.
• No output from the selected input source.
• No operation performed on the remote control.
<SPEAKERS A/B>, <LOUDNESS>, <SOURCE
• No operation of
DIRECT> <INPUT SELECTOR>
or .
ENGLISH
Power indicator
Flashes three times
on the remote control.
11