Setting Remote Control Codes - Marantz PM6007 Owner's Manual

Contents Connections

Setting remote control codes

REMOTE
MODE CD
ENTER
Front panel Rear panel
Playback
Remote control codes are set between this unit and the supplied remote
control. You can select one of the three types of remote control codes, and
the remote control can be used to control the unit when the same remote
control code is used. If three of these units are used in the same location,
all three units can be controlled simultaneously using one remote control
in the default settings. By setting individual remote control codes between
a unit and the remote control, the remote control can be used to control
only the unit that has the same remote control code.
Be sure to check the operation of each unit after setting the remote control
codes.
The default setting is "AMP1".
0 Set the remote control cord to "AMP 1" when controlling this unit from a Marantz
1 - 3
Remote control 34
unit
Settings Tips
network audio player or other device connected using a remote connection cable
to this unit. (v p. 23)
Index
Appendix