Table of Contents
Advertisement
EN
Creader Professional 129 EVO / EVO+
■
If the network you chose is open, you can connect directly;
■
If the selected network is encrypted, you have to enter the right security
key (network password).
Note: If you choose "Ignore" in WLAN setup, it will go into the date setting page.
If the tool has been properly connected to the Internet, the system will automatically
obtain the correct network date and time and navigate to step 6.
6.
After the network connection is done, tap "Next Step" to configure email address.
Input the email address, and tap "Next Step" to go to next step.
Note: You are strongly recommended to fill in the valid email address. Once you
configured this option, the system will automatically send the diagnostic report to your
email box every time a complete Auto-Detect process is successfully finished.
7.
Carefully read all terms and conditions of the user agreement, check the box befo-
re the "Agree to all the above terms", and tap "OK" finish the sign-up process and
navigate to Job Menu.
4.3 Job-Menü
Es umfasst hauptsächlich die folgenden Funktionsbausteine.
5.
DIAGNOSE
5.1 Connection
1.
Turn the ignition off.
2.
Locate vehicle's DLC socket: It provides standard 16 pins and is generally located
on driver's side, about 12 inches away from the center of dashboard. See Figure
2-2. If DLC is not equipped under dashboard, a label indicating its position will be
given. In case no DLC is found, please refer to Automobile Repair Manual.
3.
Plug one end of the diagnostic cable into the DB-15 connector of the tool, and
tighten the captive screws. Connect the other end to the vehicle's DLC.
Vehicle`s DLC
16
Diagnostic Cable
Creader Professional 129 EVO / EVO+
Advertisement
Table of Contents
