Care And Maintenance; Replacing The Pre-Filter - Surgically Clean Air SCA7000H Operational Manual

Chapter 6

CARE AND MAINTENANCE

WARNING
Cleaning the unit while it is
plugged in may result
electric shock, electric
spark and serious injury.
Unplug the unit before
cleaning or maintenance!
E-14
To maintain optimum performance of this air purifier, the Pre-filter, the
HEPA filter, the VOC filter and the UV-C+ bulb need to be replaced when
the indicator lights are flashing. When replace the filters, be sure to
unplug the power cord, and never handle the plug with wet hands. If so,
electrical shock and bodily injury may occur as a result.
Main Unit
Wipe with a dry, soft cloth for stubborn stains or dirt. Do not use volatile
fluids, Benzene, paint thinner, polishing powder, this may damage
the surface. Do not use detergents, detergent ingredients may damage
the unit. Keep the unit away from water.

Replacing the Pre-filter

When the " " indicator light on the control panel flash, the Pre-filter
needs to be replaced.
6-2 Removing the Pre-filter
• Remove the filter blocker.
• Pull the Pre-filter straight up and
out of the front panel.
CAUTION:
• DO NOT reuse or clean the Pre-filter with flammable substance.
• Remove plastic packaging from the Pre-filter before operation.
• After replacing the Pre-filter, hold the SPEED button 2 seconds
to reset the time for the Pre-filter.
6-1 Open the front panel
• Stop the operation and unplug the
unit.
• Hold the front panel upper portion
(Left and right side) and pull it
toward you.
Remove the swing
screw and take off the
filter blocker.