Summary of Contents for Surgically Clean Air Sur301F
Page 1
WARNING:To reduce the risk of electric shock, this equipment has a grounding type plug that has a third (grounding) pin. This plug will only fit into a grounded power outlet. If the plug does not fit into the outlet, contact a qualified person to install the proper outlet. Do not alter the plug in any way.
BEFORE OPERATING, READ ALL INSTRUCTIONS IN THIS MANUAL CAREFULLY. CONTENTS FOR CUSTOMER ASSISTANCE CONSUMER LIMITED WARRANTY HOW IT WORKS FEATURES AND SPECIFICATIONS IMPORTANT SAFETY PRECAUTIONS WARNING CAUTIONS CONCERNING OPERATION PART NAMES AND DESCRIPTION Main Unit Part Numbers and Names BEFORE OPERATION Remote Control Setup OPERATION Display Indicator Lights...
Telephone Address Phone: 1-877-440-7770 Write: For service problems, guarantee information, missing items and other assistance: SURGICALLY CLEAN AIR 3451 Lake Shore Blvd. West Toronto, ON M8W 1N2 Please provide the following information when you write or call: model number, serial number, date of purchase, your complete mailing address (including Postal Code), your daytime telephone number (including area code) and description of the problem.
LIMITED WARRANTY Congratulations on your investment Surgically Clean Air gives you the following limited warranty for this product only if it was originally purchased from Surgically Clean Air or from an authorized dealer. Surgically Clean Air warrants that this product is free, under normal use and maintenance, from any defects in material and workmanship.
HOW IT WORKS The air purifier functions as an air cleaner by helping to disinfect airborne microorganisms and removing particulates from the air. The centrifugal fans of the unit draw air through the front panel (Intake) on the front of the unit.
No screws, hooks or tools are required. The electronic cell captures small particles on aluminum plates that are simply rinsed off in the sink. There are no expensive filters to replace. Specifications Model No. Sur301F (SCA301F) Power Requirement 120V, 60Hz, 1.1A Rated Power 130W - 180W...
-Remove the power plug from the wall outlet before cleaning the unit and when not using the unit. Turn off all controls before unplugging. -If the power cord is damaged, it must be replaced by the Surgically Clean Air authorized service or similarly qualified person.
Page 8
IMPORTANT SAFETY PRECAUTIONS This manual classifies precautions into WARNINGS and CAUTIONS. Be sure to follow all precautions below: They are important for ensuring your safety. WARNING: If you do not follow these instructions exactly, the unit may cause property damage, personal injury or loss of life. CAUTION: If you do not follow these instructions exactly, the unit may cause minor property damage or personal injury.
Page 9
IMPORTANT SAFETY PRECAUTIONS DO NOT wash or reuse the activated carbon The activated carbon filter must be located filter or clean the activated carbon filter with behind the cell. DO NOT place the activated liquid, especially alcohol, gasoline, paint carbon filter in front of the cell. It may cause thinner, etc.
Page 10
IMPORTANT SAFETY PRECAUTIONS Do not disassemble or modify this Use a fuse with proper capacity. Never use equipment. a wire in place of a fuse. Doing this may lead Unwarranted tampering can lead to fire, to malfunction or fire. electric shock and unit malfunction.
Page 11
If any parts of the power source gets wet Do not place the product in direct contact remove the plug and dry it completely before with sunlight. It may cause malfunction and reusing. deformation of the product. Page 11 ...
BEFORE OPERATION Remote Control Setup Preparing the remote control The battery is already set in the remote control, pull out the clear sheet from the battery cover before using. How to use the remote control a) Point the transmitter of the remote control towards the receiver of the main unit. If an obstruction to the signal exists, the remote control will not operate.
OPERATION Display Indicator Lights NIGHT Indicator Light When the NIGHT button on the remote control is pressed the light will light up. Air Pollutant Indicator Light When the power plug is inserted into the outlet the indicators will flash. AUTO Indicator Light When the unit is at Auto mode, the light will light up.
OPERATION Main Unit Operation Connect the Power When the power plug is inserted into the wall outlet, all the indicators on the display panel will light up for 2 seconds (As shown in the diagram below). 1. POWER Button Press the POWER (On/Off) button to start operating the unit. Holding the button 3 seconds, it will reset the timer for the replacement of activated carbon filter or the UV lamps.
Remote Control Operation Power (ON/OFF) Button The unit will start operating when the POWER button is pressed. Pressing the button again will stop operation. SPEED Button The fan speed can be switched among Low, Medium and High settings. TIMER Button The set time switches every time the button is pressed as shown below.
CARE AND MAINTENANCE WARNING Cleaning the unit while it is plugged in may result electric shock, electric spark and serious injury. Unplug the unit before cleaning or maintenance! To maintain optimum performance of this air purifier, please clean the unit including the Pre-filter and electronic cell periodically.
Page 19
WARNING 1. DO NOT clean the Pre-filter with flammable substances (alcohol, gasoline, paint thinner, etc.). It may cause fire! 2. After cleaning the Pre-filter, it is very important to dry it completely before placing it back in the unit. 3. During maintenance, be careful not to tip over the unit. It may cause personal injury. Be careful not to tip over the unit when moving it.
CARE AND MAINTENANCE Cleaning the Electronic Cell Remove the electronic cell 1. Stop the operation and unplug the unit. 2. Please waiting 10 seconds before opening the front panel. 3. After removing two cell clips, pull the cell out of the cabinet by using the two handles on the cell.
Replacing the Activated Carbon Filter When the FILTER LIFE indicator light on the control panel flashes yellow, the activated carbon filter needs to be replaced. 1. Stop the operation and unplug the unit. 2. After waiting 10 seconds open the front panel by holding the upper portion and pull it toward to you.
CARE AND MAINTENANCE IMPORTANT NOTE: A. Remove plastic packaging from the activated carbon filter before operation (The activated carbon filter is located behind the electronic cell). B. DO NOT clean the activated carbon filter with liquid, especially alcohol, gasoline, paint thinner, etc. It may cause fire! C.
Page 23
After replacing the activated carbon filter or the UV lamps, hold the POWER button 3 seconds to reset the time for the activated carbon filter or the UV lamps. Page 23 ...
Service problems that appear to be major can often be solved easily. You can be your own troubleshooter by reviewing the following guide. All other servicing should be done by a Surgically Clean Air authorized service center. CASE WHAT TO CHECK...
Page 27
Toronto, ON M8W 1N2 Tel: 877.440.7770 www.surgicallycleanair.com info@surgicallycleanair.com Surgically Clean Air reserves the right to revise or modify products and/or specifications without notice. The contents of this manual are subject to change without notice. 1011-200-202713 (R2) 301F1011-04 Page 27...
Need help?
Do you have a question about the Sur301F and is the answer not in the manual?
Questions and answers