Smtp Settings - 3xLogic VISIX Gen III Series User Interface Manual

Setup - Network Setup

SMTP Settings

1
2
3
4
5
6
7
8
9
10
11
To send / save the imagevia Email, SMTP needs to be setup.
General Setting - SMTP function can be enabled or disabled here.
1
Mode - Select Security mode of SMTP from Plain or SSL / TLS. After checking account setup of your SMTP Server,
2
select the correct option.
SMTP Server Address - Define the SMTP Server Address. If the IP Address form is incorrect, the user will be prompted with a
3
warning.
Port - Define the Port used in the Plain or SSL / TLS security mode.
4
User ID - Ener the User ID to access the SMTP Server. Fill out using the correct User ID registered with your email provider.
5
Password - Enter the Password to access the SMTP Server. Fill out using the correct Password registered with your email provider.
6
E-Mail Sender - Define the e-mail address of the E-Mail Sender. It will be displayed as the sender when the camera sends an
7
E-mail.
E-Mail Receiver - Define the e-mail address of E-Mail Receiver. It will be displayed as the Receiver when the camera sends
8
an E-mail.
Title - Define the title of the E-Mail when the camera sends an E-mail.
9
The title of the Email is limited to 40 characters including the spaces.
Message - Define the contents of E-Mail when camera sends an E-mail. The message of the Email is limited to 40 characters
10
including the spaces.
Click Apply to save new settings.
11
www.3xlogic.com | 877 3xLOGIC | helpdesk@3xlogic.com
Pg. 36