Emptying Residual Water - Hanseatic HWM6T214A2 User Manual

Page EN-22 Care and maintenance
6. When the water stops draining, unscrew
the lint trap all the way.
7. Remove all foreign bodies and clean the
lint trap under running water.
8. Put the lint trap back in again until it
stops.
9. Re-insert the shutter (11). Make sure the
rectangular opening in the shutter is at
the top.

Emptying residual water

CAUTION!
Risk of injury!
Improper handling of the appliance
may result in injury.
The appliance is very heavy. Nev-
■
er carry it alone, but always have at
least two persons to do so.
If the appliance is put in area prone to frost,
you must drain the residual water so that it
does not freeze in the appliance and cause
any damage.
1. Follow the steps described in the Chapter
'Cleaning the lint trap' on page EN-21, Sec-
tions 1 to 6.
2. With the assistance of another person, tilt
the appliance forward slightly to allow any
(11)
residual water to drain from the appliance.
3. Replace the lint trap once again and
screw it clockwise until it stops turning.
4. Re-insert the shutter (11). Make sure the
rectangular opening in the shutter is at
the top.
5. Unscrew the water inlet hose from the
valve and remove the drainage hose from
the tub or siphon to drain any residual
water.