Establish Drain For Water - Hanseatic HWM6T214A2 User Manual

Establish drain for water

WARNING!
Risk of scalding!
Fix the hose to the sink or bath to pre-
■
vent it from slipping due to the recoil
caused by pumping.
For drains, make sure that the cross
■
section of the discharge pipe is great
enough that the sink cannot overfl ow.
NOTICE
Risk of damage to property!
Use only the water outlet hose pro-
■
vided.
Do not extend the water outlet hose
■
or replace it with another hose.
The water drainage hose must not
■
get bent or twisted.
The bend on the water outlet hose
■
should be no more than 100 cm
above the ground, to ensure that wa-
ter can be drained off properly.
The water outlet hose must be in the
■
retaining clips on the back of the appli-
ance so that the bend always remains
above the waterline inside the appli-
ance. The end of the hose must not be
submerged in the pumped water.
Set up and connection
You can fit the outlet hose in two ways:
Fixing with a hose holder
• Put the end of the water outlet hose (14)
over a hose holder and hang it over the
edge of a bath. (You can find a hose hold-
er in a specialist shop or DIY store.)
Attaching the discharge manifold
to a washbasin
• The water outlet hose (14) is mounted
onto a special device, which can be found
on the outlet manifold of a washbasin. In
doing so, the lock on the siphon must be
removed.
Have this fixed by a specialist!
There is a washer in an unused con-
nection manifold to ensure that no
water can run out. This washer must be
replaced by a seal ring before the water out-
let hose is connected.
Page EN-25