Exiting The User Program; Error Messages - GE XDP-H2 User Manual

Accessing the User
Program (cont.)

Exiting the User Program

Error Messages

Operation
Opt Disp
Cal
To leave the User Program, proceed as follows from the main menu:
Cal Opt Disp
1 H2/AIR
91.52
Notice that the padlock is no longer visible at the upper right corner
of the display window. Once the User Program has been accessed
with a valid password, the menus at that programming level remain
unlocked when you return to run mode. With the menus unlocked,
you may reenter the User Program by simply pressing the
only. To re-lock the menus, see the instructions in Chapter 4, Setup
and Calibration.
Note: If the unit is powered down, the User Program will be locked
when the unit is powered up again.
To program a specific feature of the XDP, proceed to the appropriate
section of Chapter 4, Setup and Calibration.
As an aid in diagnosing operational problems with the XDP, the built-
in software has been designed to report several error conditions
directly on the display screen. These error messages, along with the
causes and suggested remedies are listed in Table 3-1 on page 3-6.
IMPORTANT:
Table 3-1 on page 3-6 lists the error messages in
order of priority. If multiple errors occur
simultaneously, only the highest priority error is
displayed (errors with the same priority level cannot
occur simultaneously).
This screen shows the highest
level of the User Program,
which is referred to as the
main menu.
[ESC]
Press the
You are now back in normal
run mode.
pnt
January 2008
key.
[ESC]
key
3-5