Selecting Test Routine - Bosch BSA 42 Series Operating Instructions Manual

Shut-off criteria:
R
If the vehicle runs off the set of rollers during the
brake test, causing the slip rollers to move upwards,
the drive rollers are automatically deactivated.
�.5

Selecting test routine

i
Test routines contain test steps with fixed and configurable parameters (e.g. peak value display time). After
switching on the BSA 42xx, the test routine P1 (brake test) or L1 (test lane) is selected automatically. If required,
additional test routines can be configured by Service personnel.
Step
1. Start test routine selection.
2. Select test routine.
3. Confirm test routine selected.
Robert Bosch GmbH
R
Without remote With remote
control unit control unit
Press for 15 seconds
Press one after the other
Briefly pressing
button switches
Press one of these but-
forwards
tons until the required
routine is displayed
Press for
5 - 7 seconds
Press Enter button
Operation | BS� ���� | �1
If the braking force exceeds the frictional force
between the wheel and the test rollers, the wheel
starts to slip (lock up). The drive rollers of the
BSA 42xx are automatically deactivated to avoid
damaging the tires.
Result / �nalog display
? Measurement mode is terminated.
? Indicator lamp flashes.
? LCD:
Current test routine.
+
? Both pointers on "3".
? LCD:
Test routine selected.
or
? Indicator lamp ON.
? Both pointers on "0".
? Test routine starts.
? LCD:
Drive-on prompt
"
Test routine is selected.
BS� ���� | �1 | �1 en
|
1 691 506 010 2009-05-25