Maintenance - Heta Scan-line 7 Series Operating And Installation Instructions

stove data table in accordance with en 13240 testing
Stove Nominal Smoke
type fluegas stub
Scan-Line temperature mm
series C°
7B 237 ø150
7C 237 ø150
7D 237 ø150
7D low 237 ø150
7L 237 ø150
The nominal output is the output to which the stove has been tested.
The test was carried out with the secondary air 50% open.
stove data table in accordance to norwegian fire wall
Oventype Distance to fire wall i mm
Stove
behind the
Scan-Line
serien
stove
7 B/C/D/L 50
Ventilation
Adequate ventilation must be provided in ac-
cordance with building regulations (Doc J Oct
2010) especially when installing in newer build
properties when the stove is not going to be in-
stalled to an outside air supply. Houses built af-

Maintenance

The surface of the stove has been trea-ted with
heat-resistant paint.
The stove should be cleaned with a damp cloth.
Any damage to the surface in the form of chips
or scratches can be repaired using touch-up
paint, which is available in spray cans.
Cleaning the glass
Incorrect firing, for example using wet wood, can
result in the viewing window becoming covered
in soot. This soot can be easily and effectively
removed by using proprietary stove glass clea-
ner.
Fuel Draught Nominal
volume min output
kg mbar tested
kW
1 0,12 4
1 0,12 4
1 0,12 4
1 0,12 4
1 0,12 4
at the sides
50
Heat Distance to flammable materials
output
behind the stove
%
mm
83,1 100
83,1 -
83,1 100
83,1 100
83,1 100
ter 2008 where the air leakage rate is less than
5m / hour/m then a ventilator equivalent to 550
3 2
mm2 per kW output will be required (4.5kW x
550 mm = 2475 mm
nected to an outside fresh air supply.
1
Door sealing
It is recommened at least once a year to check
the sealing of the door to see if it is intact and
correctly fitting. (See figure 1)
Distance to
furnitures from
at the sides
the stove
mm
mm
100 800
100 800
100 800
100 800
100 800
) unless the stove is con-
2
Stove
weight
kg
93
90
100
100
118
9