Rear Connection - Heta Scan-line 7 Series Operating And Installation Instructions

scan-line 7D
Scan-Line 7D is available on solid base and on
rotary base. To operate the rotary base, turn the
small handle in front of the stove.
scan-line 7 D
(fresh air)

rear connection

• Insert cover plate 66x83 mm (supplied)
through the duct and loosely down into
the bottom so that it covers the hole from
below
• You can now connect the ø100 connector
on the stove to external air flow hose. Fig.1
rear connection through
column
• Loosen screw in ø100 connector and attach
cover plate ø105 mm (supplied)
• Remove the plate on the column and seal
the hole with silicone before pressing the
connector into place. Fig 2.
Scan-Line 7D is
available on
solid base
optional connection of external air flow
Scan-Line 7 D on rotary base.
(Rotates 45 degrees til each side)
1
2
Extra purchase
Item no. 1515-0011
17