Using The Remote Control - Valor G3 Classic Installation & Owner's Manual

OWNER'S
INFORMATION
Radio Frequency
315 MHz for USA and Canada.
This device complies with Part 15 of the FCC Rules and
with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
NOTE: Before using the remote control system for
the rst time, the receiver and the handset must
be synchronized. See the section Synchronize Remote
Control.
IMPORTANT: BEFORE YOU BEGIN, please note that on
this system, the settings of time/temperature can only be
programmed when the function display is ashing.
Be patient when programming as it can take a few seconds
to set.
To communicate, the handset should be within 15 feet
(4.5 meters) of the replace.
Do not leave the handset on the mantel or hearth.
Current
temperature Handset
(F or C) sensor
OFF
(turns the burner
8

Using the Remote Control

Battery status
Current time
(12 or 24 hour clock)
Turn Fireplace ON
Press + buttons until you hear a
short beep; release buttons.
Beeping continues until pilot is lit.
NOTES:
On the valve, MAN button must be at
ON, in full counter-clockwise position
.
ON/OFF switch (if equipped) must be in I (ON) position.
Turn Fireplace OFF
Press button.
When pilot is just turned o , wait 2
minutes to light it again.
Standby Mode (Pilot Flame)
Press and hold to set replace
to pilot.
Adjust Flames Height
With pilot lit, press and hold buttons:
= increase ame height
= decrease ame height or
set to pilot
For ne adjustment, tap buttons.
Set the di erent parameters when
they are ashing.