Replacing Batteries; Using Handset Wall Holder - Valor G3 Classic Installation & Owner's Manual

OWNER'S
INFORMATION

Replacing Batteries

WARNING
!
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the fi replace cool fi rst before touching it.
CAUTION
DO NOT USE a screwdriver or other metallic object
to remove the batteries from the battery holder or
the handset! This could cause a short circuit to the
receiver.
Low battery signal: see page 9.
BEFORE changing the batteries, disconnect the
battery holder from the receiver.
The appliance uses four 1.5 V AA alkaline batteries
for its battery holder and one 9 V alkaline battery for
its handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the off -
season will extend the battery life. Should the batteries
lose power, the control may be operated by manually
turning the control knob at the valve or by turning off
the valve at the switch.
To replace the batteries in the battery holder:
1. The battery holder is located underneath the fi rebox
behind the lower panel. Unhook the panel. Grab the
battery holder and pull it out.
Battery holder
16
Servicing & Maintenance
2. Disconnect the battery holder.
3. Replace the batteries with 4 AA alkaline batteries.
4. Reconnect the battery holder.
5. Put the battery holder back in its position.
DO NOT let the cable touch the burner plate above, it
will melt during operation.
6. Hook the lower panel.

Using Handset Wall Holder

Your fi replace equipment includes a wall
holder to store the handset. If it hasn't
been installed, refer to the instructions
further on in this manual for the
installation.
CAUTION