Connect Venting - Valor G3 Classic Installation & Owner's Manual

Connect Venting

IMPORTANT: This appliance's venting system is room sealed and
therefore, does not require room air to be used in the combustion
process.
1. Rough-in two 3" diameter vent liners into the existing
chimney system from the roof. Be careful not to tear or
damage the liners in the process. It may be easier to
install both liners at the same time rather than one at a
time. Leave plenty of liners at the bottom to facilitate the
connection of the liners to the vent slider. It is best to leave
the top termination until later.
Designate and mark the top and bottom of one liner as
"EXHAUST" to avoid confusion later.
2. Release the two screws retaining the vent slider to the
front of the fi rebox. Remove the slider from the fi rebox by
sliding it towards the back of the fi rebox.
3. Fit the two liners ensuring that the exhaust liner is
connected to the identifi ed "EXHAUST" vent collar.
Secure liners to collars with hose clamps (included) and 2
tapping screws per liner.
4. Slide the fi rebox onto the vent slider in the cavity taking
care not to damage the liners. Make sure that the rear
edge of the slider is hooked over the cleat on the
fi rebox. Secure the vent slider to the front of the fi rebox
with two screws removed earlier.
5. From the roof, pull the liners and fi t the fl ashing.
6. Fit the terminal
cap ensuring that
the exhaust liner
is connected to
the exhaust vent
collar. Secure with
8 screws provided.
7. Seal the terminal
and fl ashing from
water penetration
as required.
WARNING
WARNING
!
Failure to position the parts in
accordance with these diagrams
or failure to use only parts
specifi cally approved with this
appliance may result in property
damage or personal injury.
Installation
2
Vent slider
cleat
7
4
QUALIFIED
INSTALLER
6
5
1
3
25