Luna BBD 100 Original Instructions Manual page 36

Scale label
AUxILIARY MOUNTING FOR VERTICAL
SANDING
1. Remove backstop lock bolt and remove work support.
2. Remove table assembly by removing table lock knob and was-
her.
NOTE: Belt bed may be raised to vertical position by loosening
hex socket screw and raising bed. See "Position belt bed".
3. Attach table assembly to auxiliary holes in belt bed. Make sure
index pin is in the upper hole when sanding table is in the verti-
cal position.
Auxiliary mounting
holes
Backstop removed
Owners
manual
10 pages
Work table
Table lock knob
Table support
Washer
Table lock
knob
Pulley
cover
SQUARING TABLE ASSEMBLY
WARNING: To avoid injury from accidental start, make sure tool
is unplugged before aligning.
1. Using a combination square, check the angle of the worktable
with the disc.
NOTE: The combination square must be "true" - See "Unpacking
- Tools Needed" section on page 6 for checking method.
2. If the table is not 90° with the disc, loosen table lock knob screw
and tilt table.
3. Adjust worktable square to the disc and retighten table lock
knob.
Scale label
INSTALLING THE SANDING BELT -
TENSIONING AND TRACKING
WARNING: To avoid injury from accidental start, turn switch
"off", remove pluge from power source outlet before removing or
installing sanding belt.
34
Combination
square
Worktable
Table lock knob