Adjusting The Output Level Of The Punch Waste Full Sensor; Operation Check - Canon 2/3 Hole Puncher Unit-A1 Service Manual

Adjusting the Output Level of
the Punch Waste Full Sensor
After installing this equipment, adjust the output level of the
Punch Waste Full Sensor as follows.
1. Enter the following item in the Service Mode and
then press the OK button on the screen.
Service Mode (Level1) > SORTER > FUNCTION > FN-
SENS2
2. When completing the output level adjustment
successfully, the "OK" is indicated on the screen.
NOTE:
If the "NG" is indicated on the screen at the step 2, retry
the adjustment by repeating the step 1. If the "NG" is
indicated after retrying the adjustment, check whether
there is not the malfunction in attachments and
connections of the Punch Waste Full Sensor Unit and the
surrounding area.

Operation Check

1. Turn ON the main power of the host machine.
2. If a message prompting the user to update the
version appears, press [Update] to automatically
update the version of this equipment.
NOTE:
If [Skip] is selected, a message prompting the user to
update the version will appear every time the host machine
is started. In the service mode (Level 2) shown below, it is
possible to set not to display the message.
（Level2）COPIER > OPTION > FNC-SW > VER-CHNG
3. Check the operation such as paper feed and punch
operation to make sure that problems such as a jam
or malfunction do not occur.
NOTE:
If the punch hole position of this equipment needs to be
adjusted, go to checking and Adjusting the Punch Hole
Position.
61
6. Installation