Canon 2/3 Hole Puncher Unit-A1 Service Manual page 53

• Adjustment procedure
1. When the punch hole position in the feed direction is not the standard, adjust the punch feed direction position.
<Standard>
L=12 ± 1.5mm
2. Enter the following service mode to adjust the feed direction position of the punch hole.
- (Lv.1) SORTER ＞ ADJUST ＞ PNCH-X
When the setting value is changed by 1, the punch position L shifts by 0.1mm.
+: L becomes larger (The punch hole shifts toward delivery direction.)
-: L becomes smaller (The punch hole shifts toward inlet direction.)
NOTE:
Adjustment range: -25 to 25
However, this adjustment cannot be executed when setting the punch mode to the precision priority.
3. Make a print by the punch mode and check the feed direction position of the punch hole. When the punch feed direction
position is not the standard, adjust by repeating from the step 2 again.
<Rear>
Delivery
direction
<Front>
L
47
5. Adjustment