Canon 2/3 Hole Puncher Unit-A1 Service Manual page 66

17. Install the Rear Inner Cover (small).
• 1 Screw (TP ; M3x6)
• 2 Bosses
NOTE:
Use the screw removed in step 3.
1x
18. Insert the Punch Waste Tray in the direction of the
arrow from the front.
19. Close the Front Cover of the Finisher.
20. Install the Rear Cover of the Finisher.
• 3 Screws
• 2 Claws
3x
21. Refer to the installation procedure of the finisher to
Install this equipment to the upstream connection
machine.
22. The following parts remain after installing this
equipment. Make sure not to leave the remained
parts at the site.
Inlet Feed
Guide x1
Screw
(TP;M3x6) x1
60
6. Installation
Claw
Rear Inner Magnet Unit
Cover x1 x1
[5] Punch Cover
(Front) x1