Canon 2/3 Hole Puncher Unit-A1 Service Manual page 69

Table of Contents

Advertisement

2. Lift the Punch Unit. Loosen the screw fixing the
Punch Unit positioning Guide, and then move the
guide referring the scale. After adjusting, tighten the
screw.
NOTE:
When L1 > L2: Move the guide to the right.
When L1 < L2: Move the guide to the left.
Loosen
3. Lower the Punch Unit, and then close the front cover
of the finisher.
■ Side Registration Adjustment
(Service mode adjustment)
When the side registration is not within the standard (when
L3 is not within the standard), make the adjustment according
to the following procedure.
1. Enter the following service mode to adjust the side
registration.
Service Mode (Level 1) > SORTER > ADJUST > PNCH-
Y
NOTE:
When the setting value is increased by 1, L3 increases by
0.1mm.
+: L3 increases. (The punch holes shift to the rear.)
-: L3 decreases. (The punch holes shift to the front.)
2. Exit the service mode.
scale
1x
1x
Tighten
■ Paper Stop Position Adjustment
(Service mode adjustment)
1. Enter the following service mode to adjust the paper
stop position.
Service Mode (Level 1) > SORTER > ADJUST > PNCH-
X
NOTE:
When the setting value is increased by 1, L1 and L2
increase by 0.1mm.
+: L1 and L2 increase. (The punch holes shift to the
delivery direction.)
-: L1 and L2 decrease. (The punch holes shift to the inlet
direction.)
When setting the punch mode to the precision priority, this
adjustment cannot be executed.
2. Exit the service mode.
63
6. Installation

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2/4 hole puncher unit-a14 hole puncher unit-a1

Table of Contents