Adjustment; Adjustment At Time Of Parts Replacement; Adjusting The Tray Full Sensor Position - Canon Shift Tray-D1 Service Manual

Chapter 4

4.2 Adjustment

4.2.1 Adjustment at Time of Parts
Replacement
4.2.1.1 Adjusting the Tray Full
Sensor Position
Adjusting the Position of the Shift Tray Full Sensor
Be sure to go through the following whenever you
have removed/replaced the tray full sensor (front,
rear):
1)Remove the 3 face covers [1].
[1]
2)Remove the 2 screws [1], and detach the delivery
unit [2].
[1]
3)Loosen the screw [1], and temporarily fix both of
the tray full sensors [2] in place where they are
farthest from the paper.
4-2
0009-3531
F-4-2
[2]
F-4-3
[1]
[2]
4)Place a stack of paper about 60 mm in height over
the point of detection of either of the tray full sensors
on the shift tray.
5) Turn on the host machine's main power switch.
Then set COPIER>FUNCTION>SENS-ADJ>STCK-
LMT in the host machine's service mode, and press
the OK key.
6)While referring to the indication, move the sensor
closer to the paper, and fix it in place where 'ON' is
indicated.
[2]
[1]
F-4-4
F-4-5