Canon 2/3 Hole Puncher Unit-A1 Service Manual page 55

• If backup operation has been performed
1. rite the backup data to the new PCB in the host machine's service mode.
• (Lv.1) SORTER ＞ FUNCTION ＞ PUN-BK-W
2. Turn the main power of the host machine off and then on.
• If backup operation has not been performed
1. Based on the output setting values (P-PRINT), enter the adjustment values and setting values for the following items in
service mode.
Service Mode
SORTER ＞ ADJUST
SORTER ＞ OPTION
NOTE:
The adjustment and setting values of the following service mode are stored by the finisher.
- (Lv.1) SORTER ＞ ADJUST ＞ PNCH-X
- (Lv.1) SORTER ＞ OPTION ＞ PUCH-SW
- (Lv.1) SORTER ＞ OPTION ＞ PNCH-SW3
2. Enter the following service mode to adjust the sensor.
• (Lv.1) SORTER ＞ FUNCTION ＞ FN-SENS1: Adjusting the punch horizontal registration sensor
• (Lv.1) SORTER ＞ FUNCTION ＞ FN-SENS2: Adjustment the punch waste full sensor
NOTE:
When completing the sensor adjustment successfully, the "OK" is indicated on the screen. If the "NG" is indicated, retry the
adjustment after checking whether there is not the malfunction in attachments and connections of the sensor unit and the
surrounding area.
PNCH-Y Adjusting the punch hole position in the horizontal registration direction
PUN-Y-SW Setting whether to perform the horizontal registration operation of the puncher
unit for matching with the center of the paper
PNCH-SW2 Setting the punch hole specification of the puncher unit
49
5. Adjustment
Items